1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
|
Other Setups
============
Dumb servers
------------
Bazaar can also serve branches over protocols that know nothing about Bazaar's
specific needs. These are called "dumb servers" to distinguish them from
Bazaar's native protocol. Currently HTTP, FTP, SFTP and HTTP+WebDAV can be
used to read branches remotely. FTP, SFTP and HTTP+WebDAV can be used for
writing as well. To use any of these protocols, it is just necessary to
provide access to the server's filesystem under ``/srv/bzr``.
For example, for Apache to provide read-only access to the branches
in ``/srv/bzr`` the configuration may look like this::
Alias /code /srv/bzr
<Directory /srv/bzr>
Options Indexes
# ...
</Directory>
and users could use the URL ``http://server.example.com/code/projectx/trunk``
to refer to the trunk branch.
Note that SFTP access is often available whenever there is SSH access and it
may be a good choice when Bazaar cannot be installed on the server to allow
``bzr+ssh://`` access. Dumb servers are slower by their very nature than the
native protocol, but they can be a good choice in situations where the
software and protocols that can be used on the server or the network is
limited.
Smart server over HTTP(S)
-------------------------
Bazaar can use its native protocol with HTTP requests. Since HTTP is a network
protocol that is available on many networks, this can be a good option where
SSH access is not possible. Another benefit of this setup is that all of the
authentication and access control methods available to the HTTP server (basic,
LDAP, ActiveDirectory, etc.) are then available to control access to Bazaar
branches. More information about setting up this type of access using Apache
and FastCGI or mod_python or WSGI is in the `smart server section of the User's
Guide <../user-guide/http_smart_server.html>`_.
Direct Smart Server Access
--------------------------
The built-in server that is used by ``bzr+ssh://`` access can also be used as a
persistent server on a dedicated port. Bazaar's official port is 4155,
although the port used can be configured. Further information on running the
Bazaar smart server from inetd, or directly from the shell is in the `User's
Guide <../user-guide/server.html#inetd>`_. The dedicated Bazaar server does
not currently perform any authentication, so this server by default provides
read-only access. It can be run with the ``--allow-writes`` option, but the
smart server does not do any additional access control so this may allow
undesired people to make changes to branches. (Which of course can be
reverted.) If the user that runs the server has write access to the branches
on the filesystem, then anyone with access to port 4155 on the server can make
changes to the branches stored there.
|